Many request how to made USB WIFI extender cable on my
youtube pages in english version. Maybe this explanations will help you, I hope. There are two method connection. The first
soldering connection follows on Table 1. The second soldering follows on Table
2. But in my experiment the cables working good with
solder direction on Table 2, they can working up to 17 metres may be
up to 20 meters.
Teble 1. Soldering direction from
Mr Goen and Onno
UTP cables color
USB terminal/cables color
orange white –
orange (2 cables)
red
green white (1
cable)
white
green (1
cable)
green
blue white, blue,
brown white, brown (4 cables)
black
Tabl 2. Soldering direction from
me (Arif Johar Taufiq)
UTP color
USB terminal/cables color
orange white,
orange (2 cables)
red (+vcc)
green white (1
cable)
white
gree (1 cable)
green
brown white, brown
(2 cables)
black (-vcc)
blue white, white (2
cables)
chasing/body USB
(soldered at chasing/body UFD)
Figure a. USB WIFI
Figure b. USB cables
Figure c. USB cable terminal cut for two
Figure d. Cut off USB cable and data terminal explanation
Figure e. UTP cable
Tools and material :
1.USB cables cut and use only their
body/chasing (for professional only, soldering at his terminal) for amateur just cut UFD cables be two
cables.
2. UTP cables use Belden CAT-5
3. Solder and tenol
4. Rubber isolation
5. Glue gun
6. USB WIFI any brand.
The keys
The key for successfully to make USB WIFI extender is any
cables for GND/CHASING/BODY to connect with PC. For professionals electronics hobby maybe can experiment for up to 20 meters or more with voltage injection.
Uses IC regulator LM7805 with source voltage from power supply PC (+12V) and
place near USB WIFI on the top.
To testing
Use your flash disk to test your USB WIFI EXTENDER, doing
write and read data from its.
